If you select an object for a second time, diskpart still emits a message indicating that the object is selected. Harry's question is valid. What do you get when you select the Flash Drive and then LIST PARTITION? ![]() Here's a transcript of a diskpart session, for reference: DISKPART> list disk Disk ### Status Size Free Dyn Gpt -------- ------------- ------- ------- --- --- Disk 0 Online 596 GB 11 MB Disk 1 Online 954 MB 0 B DISKPART> select disk 1 Disk 1 is now the selected disk. DISKPART> list part Partition ### Type Size Offset ------------- ---------------- ------- ------- Partition 1 Primary 953 MB 64 KB DISKPART> select part 1 Partition 1 is now the selected partition. DISKPART> list part Partition ### Type Size Offset ------------- ---------------- ------- ------- * Partition 1 Primary 953 MB 64 KB DISKPART> sel part 1 # Second Select Part Partition 1 is now the selected partition. # same 'object selected' message DISKPART> detail part Partition 1 Type: 0B Hidden: No Active: Yes Offset in Bytes: 65536 Volume ### Ltr Label Fs Type Size Status Info ---------- --- ----------- ----- ---------- ------- --------- -------- * Volume 4 E NEW LABEL FAT32 Removable 953 MB Healthy DISKPART> set ID=AF DiskPart successfully set the partition ID. DISKPART> list part Partition ### Type Size Offset ------------- ---------------- ------- ------- * Partition 1 Primary 953 MB 64 KB DISKPART> detail part Partition 1 Type: AF Hidden: Yes Active: Yes Offset in Bytes: 65536 There is no volume associated with this partition. I hope this is helpful. I was trying to do something similar so this may help you: I wanted to select the partition so that I could then delete it. This was necessary so that I could then use the windows version of dd. I was not able to select the partition with the asterisk. I tried selecting another disk and another partition, but as soon as I selected the target disk again the partition 1 was auto-selected with the aterisk. Since all I wanted to do was delete the partition, I was able to use the command within diskpart, so something like this: diskpart list disk select disk 4 clean If you then run detail disk you will see that the status has changed to 'unusable'. I was then able to run my dd command from an image to this sd card. I had the same problem with the partition being listed with asterisc (selected) but could not select it and I had the no partition selected problem and after reading the solutions here and in other places I removed the partition with clean and then re created it and made it active and then formatted the drive again in Disk Management. I still do not know yet how to put system on it to make it bootable I did DISKPART> clean to clean the partition. Love love shine stepmania download full. Issue at post is 'Boot Logical Drive is Configured but is missing or Offline' Diagnostics yield nothing useful to me or HP support. Boot disk is not selected on. Virtual city playground crack pc.
0 Comments
Leave a Reply. |